dinghy seats

What's on your mind? Anything generic goes here.

dinghy seats

Postby dreamer*65 on Mon May 14, 2018 3:26 pm

I have a R27 RIB 8' factory issue dinghy and would like to know about seats that can be installed. Looks like there are some straps on each side inside the dinghy for some kind of slip in bench seats? Any suggestions/ideas would e helpful.

Posts: 65
Joined: Sun Aug 07, 2016 5:38 pm
City: marquette
State/Province: MI

Re: dinghy seats

Postby Robjen on Mon May 14, 2018 9:56 pm

I purchased a us d RIB 290 and it came with int bench. There are two locations to attach the seat. Not sure if it was meant to have one or two. I just sit on the side on the aft by the motor and my wife sits on the bench in the front position.
Posts: 14
Joined: Fri Jul 08, 2016 12:20 pm
City: Shelbyville
State/Province: KY
Ranger/Cutwater Model: R-29 CB
Non-Ranger Model: Houseboat
Vessel Name: Blind Date

Re: dinghy seats

Postby Todd2 on Tue May 15, 2018 8:37 pm

I have the same dingy as the OP. Mine was delivered with one seat (fiberglass bench), although it can be located in two places. I keep it forward for better weight distribution (where I sit). The ends have a keyway groove formed into them so that they slide over the 'strips' on either side of the dingy tubes to hold it up. It would be difficult to make a replacement. I would see if Ranger Tugs parts dept. can source one for you.

Good luck.

Posts: 52
Joined: Thu Sep 10, 2015 5:57 pm
City: Houston
State/Province: TX
Ranger/Cutwater Model: R-27

Return to Chat

Who is online

Users browsing this forum: Dagny49, tglen22 and 10 guests