Use fuses only for dashboard buttons?

Have a tech question or tidbit you wish to share with the other Ranger Tug owners? Post it here.

Use fuses only for dashboard buttons?

Postby jasonpeacock on Mon Dec 31, 2018 1:10 pm

I noticed that the dashboard buttons on my 2017 R-23 have both a 10A breaker on the actual button panel and are connected to a fuse box with appropriate sized fuses for each device/wire size.

Is there any reason to keep the 10A breakers? Could I replace the current button panels with a new panel that does not have breakers? It would be a lot less expensive! :D

Alternatively, if I used a new button panel that has breakers, could I remove the fuse boxes? Though that would require replacing wires and sizing each breaker appropriately, a lot of effort/cost/time.

I'm new to boat electronics, though I've done a lot of non-boat electronics, if there's a reason for using both circuit breakers and fuses together I'm happy to learn about it.

Thanks!
jasonpeacock
 
Posts: 11
Joined: Mon Jan 04, 2016 2:32 pm
City: Bellevue
State/Province: WA
Ranger/Cutwater Model: R-23
Vessel Name: Walrus

Re: Use fuses only for dashboard buttons?

Postby KennyMarrs on Wed Jan 02, 2019 9:48 am

Hello Jason,

The breakers on the top of each switch are for each individual system and the fuse protects the entire panel.

Thanks,
-Kenny
KennyMarrs
Ranger/Cutwater Factory Rep
 
Posts: 20
Joined: Fri Feb 23, 2018 9:55 am
City: Kent
State/Province: WA
Vessel Name: The Buffalo


Return to General Technical Discussion

Who is online

Users browsing this forum: Fisho and 3 guests