CW28 replacement prop part #?

[mferguson]

Hi there,

wondering what the replacement part # is for my 2018 CW28? I've found 3 on the ACME site with a 19 diameter and 23 pitch. I believe it's a right hand prop. There's a 1290, 1291, or 2318. Which is the correct one? What other spare hardware for a prop replacement should I carry, if any?

Thanks!

Mike Ferguson

[TBates]

Hello Mike,

The prop we install on the Cutwater 28 is an ACME #2318 (19 X 23) 4 blade no cup. All of our inboard models are a standard right hand prop. You might carry a spare cotter pin as this is usually the one that finds a way to make it into the water.

Thanks,

-Tim

[Automaticman865]

Hi, ended up replacing the CW28 prop here on the east coast with a 19 x 21 same cup. Volvo
tested the boat and we never got over 3300 rpms on the orig prop. Now I can hit ~3600 at the beginning of the season
And still hit the redline at the end of the season.
Stuart

[mferguson]

Thank you both for the info.

Stuart, FYI, I did the test run with the Volvo Service guy and we got 3500 RPM and 27 kts out of it with full fuel and water, 3 pax...so I see no reason for me to change from the factory unit. Odd that you saw such a difference...

No have to practice getting used to $2K for a spare prop... Always carried a spare in the past but I think I'll check on replacement lead times first...

Mike

[Red Raven]

You might check with Richard in Parts at Ranger Tugs to see what they have in stock. There have been times when they made a production change and sell the unused stock at discount. I picked up my spare R27 prop at less than half price that way. Not sure if there are any changes planned to the CW28.