A few questions from a new owner...

[gusweber]

Hey gang, a few questions from a new owner...first 70 miles under our belt, couldn't be more excited..

1) Anyone have issues with the electric flush head? Ours is reading full, even though we're dead empty. I'm thinking the float is stuck in the tank.
2) Thinking of putting the racor fuel/water separator. Anyone convert off of the traditional spin-on units?

Appreciate the help -- any other advice more than welcomed.

Gus

 

[Irish Mist]

Gus
I have had experance with the holding tank There are two sensors that detect levels It seems if the install is not done correctly you get false readings or if the sensors are too close together. I was told you may need to detach the sensors and sand the tank and reinstall. If you contact Andrew at the factory he will give you contact info of the manufacturer and they are very helpful.. They are located under the bed storage . I have not had much luck and just use a flashlight and lift the bed and shine a light on the tank to check levels.. There are a lot of systems on these boats and sometimes the issues do not present themselves during the checking after assembly.. But they do their best to make it right.. Welcome aboard you will enjoy your boat 🙂
🙂

 

[Todd]

I was having a lot of problems with the holding tank sensor. Sanded tank with superfine sandpaper and reinstalled several times with no luck. Finally installed using a spray on contact adhesive instead of the double sided tape and have had no further problems.