Rockjumper
Active member
- Joined
- May 27, 2021
- Messages
- 43
- Fluid Motion Model
- C-24 C
- Non-Fluid Motion Model
- Hewes
Pulled the five latches in the cockpit of my 2016 C28 today because I had noticed some water dripping into the compartments. It looked like water dripping from one of the engine compartment latches had corroded the top my my primary fuel filter causing the paint to peel. Found that none of the five had any sealants or gaskets used during installation.
The plywood in the latch cutouts had started to rot on a five year old boat that been kept garaged much of it's life.
Everything is back together with some sealant, new O rings and silicone grease in the latch mechanisms. Hopefully they will be watertight now.
It would be a good idea to check these things if you notice any water entering the aft compartments before the water does it's work on the plywood.
The plywood in the latch cutouts had started to rot on a five year old boat that been kept garaged much of it's life.
Everything is back together with some sealant, new O rings and silicone grease in the latch mechanisms. Hopefully they will be watertight now.
It would be a good idea to check these things if you notice any water entering the aft compartments before the water does it's work on the plywood.