filliefan
Member
- Joined
- Aug 25, 2015
- Messages
- 10
- Fluid Motion Model
- C-24 C
- Non-Fluid Motion Model
- Cutwater 26
- Vessel Name
- Jacob Thomas
Hi everyone,
I'm new to the forum. Just purchased a Cutwater 26, which I like a whole lot for a variety of reasons. But there is one issue for which I need some input from any of you out there who may have experienced a similar problem. It regards docking the boat under windy conditions. I was attempting to right the boat at the entrance to the fairway and, under idle speed, it seemed uncontrollable. It was moving all over the place no matter how hard I tried to steer it into position to head down the fairway. My concern was what would happen once I entered with so little margin for error in the space between the boats and slips lined up to both sides. Turning the wheel didn't elicit much of a response that would likely get me out of trouble if I started to drift. So once I started down I used my thrusters to keep me away from the boats and slips starboard. This kept the boat fairly straight until I reached my slip where I used the thrusters and a little throttle to dock the boat. But without the thrusters, I don't think I could have made it down the fairway without experiencing a little bumper car action. Not good. So how does one control the boat in the fairway without thrusters? Seems doable. The Cutwater,like the Ranger Tugs, has a relatively high profile, shallow draft and rudder for the inboard, the combination of which can make for more challenging maneuvering in windy conditions or in close quarters. But these kind of boats are as old as the hills. So, any tips on how to address this one? Much appreciated.
Thanks.
Larry
I'm new to the forum. Just purchased a Cutwater 26, which I like a whole lot for a variety of reasons. But there is one issue for which I need some input from any of you out there who may have experienced a similar problem. It regards docking the boat under windy conditions. I was attempting to right the boat at the entrance to the fairway and, under idle speed, it seemed uncontrollable. It was moving all over the place no matter how hard I tried to steer it into position to head down the fairway. My concern was what would happen once I entered with so little margin for error in the space between the boats and slips lined up to both sides. Turning the wheel didn't elicit much of a response that would likely get me out of trouble if I started to drift. So once I started down I used my thrusters to keep me away from the boats and slips starboard. This kept the boat fairly straight until I reached my slip where I used the thrusters and a little throttle to dock the boat. But without the thrusters, I don't think I could have made it down the fairway without experiencing a little bumper car action. Not good. So how does one control the boat in the fairway without thrusters? Seems doable. The Cutwater,like the Ranger Tugs, has a relatively high profile, shallow draft and rudder for the inboard, the combination of which can make for more challenging maneuvering in windy conditions or in close quarters. But these kind of boats are as old as the hills. So, any tips on how to address this one? Much appreciated.
Thanks.
Larry