profcbutler
Active member
- Joined
- Feb 16, 2024
- Messages
- 27
- Location
- North East Maryland
- Fluid Motion Model
- R-25 (Outboard)
- Hull Identification Number
- FMLT2506G425
- Vessel Name
- TUG-GETHER
I have a 2025 R25 with a bad inverter. Worked with Ranger Tug and Kisae to determine it needed to be replaced. Besides the safety issues with removing power before I start the exchange, I am hoping someone has done this on a late model R25 to give me some tips and tricks. I am very comfortable with this type of work. However, I am trying to reduce my learning curve on the best way to remove the inverter. In troubleshooting with Kisae I removed the bottom cover panel so I know how tight it is in this area. I am trying to figure the best way to get at it. I am thinking I have to remove the entire panel (Three screws at the top). Cut a few tie wraps and pull the panel outward. How is the inverter actually mounted on the wall? Again, any insight from someone who has done this would be greatly appreciated!