PicoGoss
Well-known member
- Joined
- Oct 10, 2013
- Messages
- 47
- Fluid Motion Model
- C-28
- Hull Identification Number
- FMLT25171910
- Vessel Name
- Nano
When I inspected our new to us R 25 classic, I ran the Mase 2.7 gen set for a few minutes and made sure it would run the stove top or A/C. The next time I tried it it ran for about one minute and died with absolutely no display on its control panel. I have tried pushing 'off' then 'on' with no results. Then I checked to be sure there was voltage at the gen set itself. I found the two fuses: 3 and 30 amp according to the manual. The 3 was fine, but there was a 20 that was blown. I replaced it with a 30, but still no display. I did notice that the thermal overload switch label was upside down compared to the manual, but trying it in both positions made no difference. Any ideas?