R-21EC table hardware

[rayzickrick]

What is the manufacturer of the table mounting brackets that you use on the 2014 R-21EC?
On my boat there is one on the engine cover (rear) and one on the under side of the teak
table top. I would like to get a couple more to make fish cleaning tables. Thanks, Ray Zickrick
owner of "Andi Lee"

 

[daviduphoff]

Ranger will sell you a set. Call and ask for Richard in Parts. Make sure you are sitting down when he tells you the price. I have always found Ranger VERY fair with their parts prices so they must pay a fortune for these. I looked at adding a table to my 21 but decided differently after my phone call.

 

[rayzickrick]

Thanks. I have also researched fish cleaning tables
on the internet and I see there are some that
mount to the recessed rod holder. That’s probably
the route I’ll take.

 

[daviduphoff]

I believe if you use a rod holder mounted fish cleaning table it need to be an extra long one that gets up above the rail. I don't fish so have no use for one but I remember a thread about this. I rail mounted my BBQ for this same reason, the rod holder mounts were not long enough. I would investigate a rail mounted fish cleaning table.

 

[rayzickrick]

I have that covered David. I am fortunate to work with some excellent metal fabricators. They have already built an extended version of a gimbal mount downrigger holder that works perfectly. The rigger base now sits about four inches above the rail. Ray