R21EC DRIVE SHAFT CUTLESS BEARING DIMENSIONS

[MorganR21EC]

Im changing the cutless bearing on my 2012 R21EC, I want to have the new bearing ready before I take out the old. Does anyone have the dimensions for this bearing? The drive shaft is 25,5mm (1 inch) but what is the outer dimension and length on the water cooled cutless bearing?

 

[Newf]

I went through the dealer where I bought my boat for the one I just replaced on my 2014 R21EC. I was told that this was from the supplier used for Ranger Tug.

Here is what was on the invoice.

NSI SBRG1.00X1.500x4.00 R21 CUTLASS BEARING

On the box it came in it shows that it is a
Morse Marine Bearing
BONITO
1" x 1.5" x 4"
E00800

I replaced mine because I could feel a little bit of movement, although not much, but I was going to replace the engine mount so I just wanted everything to be up to snuff. After replacing it I found that i still had about the same amount of movement with the new one so definitely could have gotten more life out it.

There's a few photos in my album that may or may not be of use to you. Good luck with your changeout..

 

[MorganR21EC]

Perfect, thank you for the info🙂