Thank you guys for all your help..turns out the code p0008 was that not enough fuel was going to the engine..i replaced the 2 fuel filters and the problem persisted. So I unscrew the hose that go from the tank to the first fuel filter and I blew on it .There was a cloge on The fuel valve so I open and cleaned it up .Now works perfect...thanks again for all your help
Trouble with code p0008 solved
- Thread starter jsaretzki
- Start date
- Status
captstu
Well-known member
- Joined
- Nov 10, 2014
- Messages
- 862
- Fluid Motion Model
- C-248 C
- Vessel Name
- Shearwater IV (SOLD)
This is been discussed several times. There’s a screen on the bottom of the tube that goes into your fuel tank. That screen was left over from gasoline engine fuel tanks and must be removed for a diesel engine. Blowing it out will help for a while. Ultimately you have to take the tube out of the tank and remove the screen or you will continue to have problems.
The root cause of the problem of course is water in the fuel. The interface between the water in the diesel fuel grows a slimy thing.
The slime clogs the screen or clogs one or more of your fuel filters or eventually clogs the injectors. Well you might not have such a serious problem that you can keep after by changing filters, the prudent thing to do is clean the tank.
Stuart Bell
Ranger 25: Shearwater
(561) 352-1796
The root cause of the problem of course is water in the fuel. The interface between the water in the diesel fuel grows a slimy thing.
The slime clogs the screen or clogs one or more of your fuel filters or eventually clogs the injectors. Well you might not have such a serious problem that you can keep after by changing filters, the prudent thing to do is clean the tank.
Stuart Bell
Ranger 25: Shearwater
(561) 352-1796
BB marine
Well-known member
- Joined
- Feb 1, 2016
- Messages
- 2,905
- Fluid Motion Model
- R-21
- Non-Fluid Motion Model
- Mainship 34 Pilot
- Vessel Name
- PORT-A-GEE
edSB":e9r25ipy said:
I removed the screen as a preventative move when I installed a fuel polishing system. The ball valve needs to be removed first. The best way to remove the valve is to remove the valve handle to give more clearance when unthreading.
The photo shows the tube location, as noted in the photo back up the nut on the tank when loosening the pick-up tube.
This is a photo of pick up tube removed with screen installed. The diesel fuel tank doesn't require the screen to be installed by ABYC. The screen is in place for Gas powered boats with anti-syphon valves installed. The screen is to protect the anti-syphon valves from debris getting caught in them and working improperly.
- Status