Putte
Active member
- Joined
- Sep 11, 2023
- Messages
- 39
- Fluid Motion Model
- C-24 C
- Non-Fluid Motion Model
- R-29 CB on order
Hello,
I have issues flushing the head. A lot of pushing back pressure, which means it has difficulty leaving the head clean after a flush, so I am suspecting the vent for the waist water tank being plugged. How do I unplugg it?
I have removed the hose from the tank and tried to push through a metal wire. The wire is only 6 ft so it did not reach the vent in the hull. I then tried, using a hose ( messy, so not recommended), and sprayed in the hose and then tried to spray from the outside and in. No water seem to go through in either direction. The vent and its attachment to the hose is not reachable. In the future I might add a door for this but I am currently far away from parts and service ( Exuma).
Your help and guidance would be greatly appreciated.
Regards,
Patrik
I have issues flushing the head. A lot of pushing back pressure, which means it has difficulty leaving the head clean after a flush, so I am suspecting the vent for the waist water tank being plugged. How do I unplugg it?
I have removed the hose from the tank and tried to push through a metal wire. The wire is only 6 ft so it did not reach the vent in the hull. I then tried, using a hose ( messy, so not recommended), and sprayed in the hose and then tried to spray from the outside and in. No water seem to go through in either direction. The vent and its attachment to the hose is not reachable. In the future I might add a door for this but I am currently far away from parts and service ( Exuma).
Your help and guidance would be greatly appreciated.
Regards,
Patrik