Fly-fish
Well-known member
- Joined
- Oct 20, 2013
- Messages
- 86
- Fluid Motion Model
- C-288 C
- Vessel Name
- Stella Maris
Hi Ranger folks-
I went out to have this year's shake down cruise. I've had the boat indoors in rack storage since November. I had a few problems today and I'd like to get some troubleshooting advice.
-The thrusters turned on at the panel (lights indicated "on") but did not work.
-I could not get the Inverter to turn on
-there was therefore no ac power for the boat.
Regarding thrusters, I have changed fuses before so I checked those out and they still looked new. I pulled the inverter manual out and it says that if the light wasn't one, then turn it on. No kidding 🙁. It seemed like it wasn't getting power at all.
Nothing looked too badly corroded since I last had the boat out in the fall.
Any ideas or a sequence I could go through to problem solve this? I ended up not leaving the dock today though the engine got to idle for a while when I was poking ariund the electrical area.
I would appreciate any of the vast experince available on the forum.
Thank you,
Mike
Blue Yonder
Camas, Washington
I went out to have this year's shake down cruise. I've had the boat indoors in rack storage since November. I had a few problems today and I'd like to get some troubleshooting advice.
-The thrusters turned on at the panel (lights indicated "on") but did not work.
-I could not get the Inverter to turn on
-there was therefore no ac power for the boat.
Regarding thrusters, I have changed fuses before so I checked those out and they still looked new. I pulled the inverter manual out and it says that if the light wasn't one, then turn it on. No kidding 🙁. It seemed like it wasn't getting power at all.
Nothing looked too badly corroded since I last had the boat out in the fall.
Any ideas or a sequence I could go through to problem solve this? I ended up not leaving the dock today though the engine got to idle for a while when I was poking ariund the electrical area.
I would appreciate any of the vast experince available on the forum.
Thank you,
Mike
Blue Yonder
Camas, Washington