TomHall
Active member
- Joined
- Oct 19, 2020
- Messages
- 34
- Fluid Motion Model
- C-28
- Hull Identification Number
- FMLT2738A111
- Vessel Name
- Dawn Patrol
Bringing this over to this section of the forum:
http://www.tugnuts.com/viewtopic.php?f=5&t=18345
2011 R27
Fresh Water pump runs non-stop.
A trickle at the head faucet.
A drip at the gally.
Tons of presser at the city water connector - when I remove the fitting (unscrew four screws) and pull the hose from the back (undo the hose clamp etc).
Plenty of pressure at the hot water heater.
Plenty of water flowing from the tank to the pump.
Pump is new.
Pump filter gasket is new.
No water leaking into bilge.
No change in water level.
No change when I open the water tank fill cap.
Any Ideas?
http://www.tugnuts.com/viewtopic.php?f=5&t=18345
2011 R27
Fresh Water pump runs non-stop.
A trickle at the head faucet.
A drip at the gally.
Tons of presser at the city water connector - when I remove the fitting (unscrew four screws) and pull the hose from the back (undo the hose clamp etc).
Plenty of pressure at the hot water heater.
Plenty of water flowing from the tank to the pump.
Pump is new.
Pump filter gasket is new.
No water leaking into bilge.
No change in water level.
No change when I open the water tank fill cap.
Any Ideas?