Hi,
When I use the the Webasto A/C unit in heat mode the system will supply heat to the cabin for a couple of minutes and increasing the temperature by a couple degrees and then the compressor shuts off prior to reaching set point, and then only the fan is on. Then a couple of minutes later the compressor will start supplying heat to the cabin for a couple of minutes more, and then the compressor shuts off again prior to reaching set point. After approximately 20 minutes of the compressor cycling on and off several times I shut the system off. My understanding is that the A/C unit should remain in heat mode supplying heat to the cabin until the ambient air reaches set point. I removed the return register and placed the temperature sensor in my hand to heat the sensor and the temperature display increased from 63 to 81 within a few second thereafter, the sensor seems to be working. I would appreciate any assistance in figuring out the possible corrective actions. Thanks, Louis
When I use the the Webasto A/C unit in heat mode the system will supply heat to the cabin for a couple of minutes and increasing the temperature by a couple degrees and then the compressor shuts off prior to reaching set point, and then only the fan is on. Then a couple of minutes later the compressor will start supplying heat to the cabin for a couple of minutes more, and then the compressor shuts off again prior to reaching set point. After approximately 20 minutes of the compressor cycling on and off several times I shut the system off. My understanding is that the A/C unit should remain in heat mode supplying heat to the cabin until the ambient air reaches set point. I removed the return register and placed the temperature sensor in my hand to heat the sensor and the temperature display increased from 63 to 81 within a few second thereafter, the sensor seems to be working. I would appreciate any assistance in figuring out the possible corrective actions. Thanks, Louis