Steadfast
Well-known member
- Joined
- Feb 21, 2016
- Messages
- 59
- Fluid Motion Model
- C-248 C
- Vessel Name
- STEADFAST
First time this has happened. Hooked up to shore power for days. Disconnect shore power, start the engine and the ECU alarm is up on the Garmin Autopilot . Battery bank 3 is reading about 8.5-9.0. The Garmin navigation screen won't start up because there is a low amp alarm. I checked the battery cables, they seemed fine. The batteries are only two years old.
All my switches are on expect for the parallel which is off. I think the guy with me turned then OFF and then on again. We notice all of a sudden #3 battery bank is now reading about 13?
We get underway and about an hour later shut down the engine. Go to restart and the # 3 battery bank shows about 8.5 again and the NAV screen is off again.
I'm not sure what we did but a few minutes later the #3 battery bank shows about 13. The guy I was with thought the batteries were probably fine but the #3 gauge or wiring was the problem???
One concern I have is the Nav screen will not power up if it thinks we only have 8.5 amps. Not sure what to do next??
Any thoughts?? Thank you Brian
All my switches are on expect for the parallel which is off. I think the guy with me turned then OFF and then on again. We notice all of a sudden #3 battery bank is now reading about 13?
We get underway and about an hour later shut down the engine. Go to restart and the # 3 battery bank shows about 8.5 again and the NAV screen is off again.
I'm not sure what we did but a few minutes later the #3 battery bank shows about 13. The guy I was with thought the batteries were probably fine but the #3 gauge or wiring was the problem???
One concern I have is the Nav screen will not power up if it thinks we only have 8.5 amps. Not sure what to do next??
Any thoughts?? Thank you Brian