couple of cutwater questions

[Cutwater28GG]

1. to get to the pipes for the heater next to inside pilot seat, can I just remove the heater from the front and pull it out? is there enough slack in the pipes? or do I need to do more surgery than that?

I want to check and tighten the hoseclamps: I think there is a small leak at this end of the coolant

2. on the cutwater, If I want to install another aerial (cellphone/wifi booster) is there a recommended method to bring the cable into the cabin?
do I have to remove the interior ceiling/side panels?
I ideally dont want to drill another hole in the cabin roof...

any advice?

 

[ronnieg]

There is enough slack for you to pull the heater out and check the hose clamps.
pease give me a call i can walk you through on hoe to best route your antenna wiring