Currituck-Too
Member
- Joined
- Feb 17, 2019
- Messages
- 14
- Fluid Motion Model
- C-26
- Vessel Name
- Currituck Too
How can I get zinc p/n 811487 for my 150 HP cummings engine? I also need the cap the zinc screws into.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Cummings 150 HP engine zinc
- Thread starter Currituck-Too
- Start date
Salty7
Well-known member
- Joined
- Jul 29, 2018
- Messages
- 136
- Fluid Motion Model
- C-26
- Hull Identification Number
- FMLR2507G112
- Vessel Name
- KIKI (2012) Yanmar 4BY2-150
Contact Tony Athens at Seaboard Marine in Oxnard, CA. 805-382-6287. He is a Cummins distributor and will be able to help you, you need the model number and serial number of your engine and to know which zinc(s) you need. The last Cummins I had there were two zincs in the aftercooler, one on the heat exchanger and two in the gear cooler, make sure you check all the zincs on your particular motor. After I knew what the sizes were I was able to buy aftermarket from boatzincs.com Be careful though, I measured my Cummins parts carefully before I ordered aftermarket, on my engine the aftermarket zinc for the heat exchanger had to be cut down about 1/4" in length to not crush the bundle inside the heat exchanger.
Currituck-Too
Member
- Joined
- Feb 17, 2019
- Messages
- 14
- Fluid Motion Model
- C-26
- Vessel Name
- Currituck Too
Hey..thanks Salty7for the information on the zinc. I'll get the information and get in touch with Tony Athens.
-
Tugnuts.com is the community hub for Ranger Tug, Cutwater, and Solara owners. Since its inception in 2008, the Tugnuts forum has grown into an active and thriving community of more than 9,000 members. It serves as both a meeting place for the best boating community online, and an invaluable archive of information.
- User menu