10PoundHammer
Active member
- Joined
- Oct 3, 2010
- Messages
- 42
- Fluid Motion Model
- C-24 C
- Non-Fluid Motion Model
- C30
- Vessel Name
- Grandpa's Hammer
Unfortunately I don't live where my boat is moored (my 27 is in Sidney; I live in Alberta a time zone away) so I can't readily stop by over the winter to regularly run the motor or put a load on it, as I understand is good for diesels.
Does anyone know the manufacturer's advice? Should I just let it sit until next March? Or have the boatminder run it every couple of weeks, even though it would be a relatively short period of time? Or turn it over to circulate the oil but not actually start the motor? I have heard conflicting information.
Have done an oil change to be on the safe side, added fuel stabilizer. Any advice on this?
tx
10 Pound Hammer
Does anyone know the manufacturer's advice? Should I just let it sit until next March? Or have the boatminder run it every couple of weeks, even though it would be a relatively short period of time? Or turn it over to circulate the oil but not actually start the motor? I have heard conflicting information.
Have done an oil change to be on the safe side, added fuel stabilizer. Any advice on this?
tx
10 Pound Hammer