Fuel Sending unit

[bryant]

I have a 2008 R 25 Ranger Tug with a Cummings 150, which is actually a mercury marine. The fuel sending unit is no longer working. I already have a hole in the floor above the fuel sending unit (must have failed once before) so getting to the unit is no problem. My question is where do I get another fuel sending unit. Are they generic, do you carry the units in stock if not where can I purchase one?
Thanks
Bryant Wheeler

 

[BB marine]

If you can get at the sending unit there should be a name engraved in the sending unit housing. The R25 and the C26 have basically the same tank 10" deep. The sending unit used with my tank was a WEMA system 9.5 " WEM SSS9.5 was the part number. I have calibrated measurements for that sending unit in this thread. viewtopic.php?f=18&t=10780&start=0&hilit=calibrations#p74140

 

[bryant]

BB Marine
Thanks for the information. I will follow your advice and take a look at the sending unit tomorrow. Let you knoa how I make out.
Bryant

 

[bryant]

BB Marine
Do you have the part number of the sending unit. Called KUS, no response (so far) and looked on their web site. Found one sending unit that looks as though it could be a replacement but not too sure. It's part number is SSS/SSL Sender 5 hole pattern Mount 9.5". Since the old part number was WEMA Systems 9.5" WEM SSS9.5 I thought it may be a match.
Thanks
Bryant

 

[BB marine]

I installed the 9.5 in my boat 5 hole. Part # WEM SSS9.5 . I know KUS took over WEMA. The WEM SSS9.5 is available from amazon as a KUS part number SSS.

 

[bryant]

KUS finally did call back their part number for that sender is SSS/SSL. Ordered it, should be here 1st of the week
Thanks for your help
Bryant