Garmin autopilot recalibration

[CaptainT]

While doing the dockside wizard to recalibrate the
GHC10 it has you test the turn direction by pressing
Arrows on the GHC10.
I’m assuming you should see the steering wheel move as the rudder
turns. Mine didn’t do anything in either direction.
Could this be a motor problem?
Where is this motor located? The installation manual says it should be mounted close to the ECU.
I’ve looked but don’t see anything resembling a motor.

 

[CaspersCruiser]

The arrow switches that move rudder position while executing the Dockside Wizard routine, WILL NOT move the wheel. You must have someone observe rudder position movement at the back of the boat as the arrow switches are being pushed at the helm.