Getting Towed & "The Ranger Network"

j&lgray

Well-known member
Joined
Nov 28, 2008
Messages
644
Fluid Motion Model
C-28
Vessel Name
Trilogy
If you do anything long enough, you will experience most everything that is fun but also nearly everything that can go wrong. We have been boating for 35 years and currently have our third Ranger Tug and we had a first: The tug had to be towed to a marina for engine service.

What happened? Cruising along at 8 MPH, being 3,500 miles from home, sipping fuel and enjoying the Florida sunshine, a screeching sound came from the engine. Within seconds, the engine alarms sounded with an overheat alarm. The tug’s speed was dropped to an idle to get out of the busy ICW channel. The engine was shut down and the anchor was dropped. On the floor of the engine compartment was the belt that drove the seawater pump. The edge was mangled but the belt was not broken. The likely cause: the 7-year-old belt with nearly 500 hours and almost 5,000 miles had failed.

This post is about having towing insurance and the Ranger Network. Owning 9 boats, I have only paid a mechanic once. Seeing the belt off the pulleys triggered an initial response to put it back on. I quickly found out that I did not have the tools or the knowledge of the technique to do even a temporary install. Also, I was concerned about other damage. On another boat, an overheated engine caused an impeller failure and replacement of the water muffler.

Trilogy needed to be towed. We are BoatUS members and simply pushing the “Send A Tow” button on the BoatUS app, caused a phone call from the dispatch center within a minute and a text message the tow was enroute with an ETA. The $1,000 tow bill was covered with our gold level membership. This is the second time that the insurance coverage was a blessing: Sliding on black ice in Wyoming, our Ranger 25 went off the freeway. Lesson: Have towing insurance.

The Ranger Network is an amazing thing. While waiting for the tow, a text message was sent to Rich/Cheryl of Roam and Mike/Jess of Illusions who were cruising in the region. They provided important information like closing the seacock while underway to avoid unwanted water from being forced into the system. They also connected with another tug owner Doug/Sandy who were at the marina that Trilogy was being towed to. When the tug arrived, Doug was waiting and provided essential help (picture no power or steering) in getting into the slip, was a welcome presence and the next day provided much needed transportation. Mike had a spare belt and another Ranger owner, Ron/Libby, brought it.

The Ranger Network is this forum and it is the fellowship and sharing of knowledge at a rendezvous. It is also about being helped and offering to be helpful. The network is an amazing thing, which we are grateful for.
 
Lessons Learned From This:

The failure of the belt was preventable by replacing it during periodic service. Though on my list for the 500 hour service, I should have learned about it – how to take it off and install it and had the tools to do the task before this. All the tools for this are available at any auto parts store. If I had, I would have recognized that it was the original belt and should be replaced because of its age way before this. The belt cannot be inspected without removing it.

Carry a spare belt. I had a spare serpentine belt and did not fully understand that the water pump is not driven by it, but by a separate belt. More than slightly embarrassed, I later found a spare water pump belt in deep storage - I did not know what that belt looked like until this event. The spare belt was provided by the first owner of the tug.

The seawater pump on the Yanmar engines 4BY and 6BY are stretch belts and many mechanics do not know about stretch belts and these should be removed and installed with a low cost installation guide tool. Stretch belts are different though they look like traditional belts. A traditional belt will NOT work in this application. Sometimes we need to gently educate the people who we pay to service our boats.

Still boating - still learning something new.
 
Hi John, I’m sorry about your broken water pump belt. Sounds like you’re still on the west coast of Florida, but if you end up on the east coast and need anything please let me know. I have a few spares and enough knowledge to be dangerous.

Tim and Donna
Gratitude
 
Glad to hear everything worked out and others were available to help out.
A stretch belt tool can be bought for around $20.00 or so. On my set I drilled a small hole in the portion you would hold onto and attached a small diameter line to it. I put the loop of line over my wrist so it doesn’t fall into the bilge when using the tool. If you have stretch belts carry these on the boat. Using screwdrivers to pry the belts off can damage the pulleys.
I’ve also read on this site that when being towed the water line coming off the packing gland should be clamped off besides closing the seacock.
 
j&lgray":gt9fhqft said:
The Ranger Network is an amazing thing.

Rich/Cheryl of Roam and Mike/Jess of Illusions.....Ron/Libby (Tug O’ My Heart)

The Ranger Network is this forum and it is the fellowship and sharing of knowledge at a rendezvous. It is also about being helped and offering to be helpful. The network is an amazing thing, which we are grateful for.
My wife and I have experienced the kind assistance of all three of these couples for which we are grateful. They are exemplary Ranger Tug owners and we try when ever possible to pay it forward.
 
j&lgray":1zia863z said:
Lessons Learned From This:

The seawater pump on the Yanmar engines 4BY and 6BY are stretch belts......and these should be removed and installed with a low cost installation guide tool.
Would you please post a photo or link to such a tool? I am not a mechanic, but I work on my boat because of incomplete, incorrect, and at times, just plain shoddy work by paid technicians. Having the right tools helps me make up for a lack of skill.
 
Boatdreamer":mzs2biul said:
.....but if you end up on the east coast and need anything please let me know. I have a few spares.....
Tim carries a few spares alright. His boat is actually a floating Ranger Tug parts warehouse.
 
Bill, maybe that’s why Gratitude has a port side list! Now if I could find a way to secure a spare 4BY2-180 to the swim platform I’d be all set for the great loop.

Tim
Gratitude
 
Boatdreamer":18ajqvuc said:
Now if I could find a way to secure a spare 4BY2-180 to the swim platform I’d be all set for the great loop.
I would not be one bit surprised to see it.
 
Back
Top