Inside distance between main trailer bunks for R-27
- Thread starter Skeeter
- Start date
- Status
Red Raven
Coupeville, Wa
- Joined
- May 14, 2015
- Messages
- 1,850
- Location
- Whidbey Island, Wa
- Fluid Motion Model
- R-27 Classic
- Hull Identification Number
- FMLT2734C414
- Vessel Name
- Red Raven
- MMSI Number
- 338190767
Our boat is on the trailer so it is a little difficult to measure the forward distance. The rear is 42.5 inches apart from the inside edge of each carpeted bunk. The front is slightly narrower but I can't measure it with the boat on the trailer.
You might also try asking EZ loader if the Ranger guys don't come back with an answer.
Curt
You might also try asking EZ loader if the Ranger guys don't come back with an answer.
Curt
Skeeter
Active member
- Joined
- Jan 23, 2017
- Messages
- 26
- Fluid Motion Model
- C-28
- Vessel Name
- Peggy O'
Thanks for the info. I am retrofitting a trailer I had for a previous 29' boat to a 27' Ranger. Can you tell me how far forward the main bunk is from the tail of the trailer and the model# of the trailer. Thanks again.
Red Raven
Coupeville, Wa
- Joined
- May 14, 2015
- Messages
- 1,850
- Location
- Whidbey Island, Wa
- Fluid Motion Model
- R-27 Classic
- Hull Identification Number
- FMLT2734C414
- Vessel Name
- Red Raven
- MMSI Number
- 338190767
Skeeter,
I sent you a PM on this.
Curt
I sent you a PM on this.
Curt
Scuffy
Well-known member
- Joined
- Mar 5, 2015
- Messages
- 473
- Fluid Motion Model
- C-28
- Hull Identification Number
- FMLT27161
- Non-Fluid Motion Model
- Float On Tandem Axle Trailer
- Vessel Name
- Tinytown
- MMSI Number
- 338190746
We have a Float On tandem axle trailer. The inside measurement on the front of the bunks is 40 1/2" and the rear end is 39 3/4". Not sure if that is by design or just where it ended up.
- Status