inverter won't power up

Merganser

Member
Joined
May 22, 2018
Messages
10
Fluid Motion Model
C-24 C
looking for suggestions regarding my Inverter. My boat is an R23. I have many times started the inverter with no problems. I found a reset for the inverter near the battery's, no luck. Everything works in the boat with the exception of the Inverter.
Any suggestions would be helpful.

Thank You
Gary
 
I would use a multi meter and check that there is power (12 volt DC) going to the inverter. There should be a switch and fuse between it and the batteries that supply power to it. If power to the inverter is good you may have to unship the inverter and check its internal fuses. They are usually ATAC fuses like those used in a car.
 
Thank you martin610
I will start with your thoughts, and I will let you know. I have read every post on this site regarding Inverters, and have tried everything with no avail.

Again Thanks
Gary
 
I don't know if my inverter is similar to yours or not, but I had a similar problem. All visible fuses and circuit breakers appeared to be OK, but the inverter wouldn't turn on. The problem turned out to be what I couldn't see. By reaching up through a hole near the entrance to the cave, I could feel the completely hidden inverter. Exploring the area more with my fingers, I located what felt like a GFI reset button. Pressing it resolved the problem.

Marshall
 
Thanks Marshall, I will explore that possibility. I saw that hole and was going to look in there with a flashlight before I started to take the Inverter off the wall.

Gary
 
Back
Top