Johnson pump bilge pump alarm?
- Thread starter bensmiata
- Start date
it4llc
Well-known member
- Joined
- Oct 18, 2020
- Messages
- 302
- Location
- Arlington, VA
- Fluid Motion Model
- C-28
- Hull Identification Number
- FML28C17K920
- Vessel Name
- Gremlin
On our 2020 C28, it is tied to the forward bilge pump.
trailertrawlerkismet
Well-known member
- Joined
- Feb 23, 2011
- Messages
- 2,519
- Fluid Motion Model
- C-24 C
- Vessel Name
- (2022) Kismet
Confirming on the R29S we had, it was on the forward bilge pump.
Jim
Jim
- Joined
- Aug 19, 2014
- Messages
- 547
- Fluid Motion Model
- C-24 C
- Non-Fluid Motion Model
- Cal 2-25
- Vessel Name
- S/V Saylee
- MMSI Number
- 338124769
Hi all,
The high bilge alarm is not wired to the fwd bilge pump, but yes it does sit in close proximity to it. You will notice there are two circles molded into the side of the alarm sensor. You can test the sensor by placing the alarm in the "armed" mode and placing one fingertip in each of the circles until you hear the shrill beep at the panel. Hope this helps.
Cheers,
Ralf
The high bilge alarm is not wired to the fwd bilge pump, but yes it does sit in close proximity to it. You will notice there are two circles molded into the side of the alarm sensor. You can test the sensor by placing the alarm in the "armed" mode and placing one fingertip in each of the circles until you hear the shrill beep at the panel. Hope this helps.
Cheers,
Ralf