No power to Onan Generator start switches

B

Bhin53575@yahoo.com

New member
Joined
Sep 13, 2018
Messages
2
Location
Door Co WI
Fluid Motion Model
C-30 S
Hull Identification Number
FMLC3016J415
Vessel Name
Godspeed
Our 2015 C30 Onan Generator is not showing any power to the remote or on generator start switches. We confirmed 13.5 volts going to the generator. Technician thinks it may be a faulty kill switch.

Any thoughts or experience with this issue?
 

Attachments

  • IMG_8474.jpeg
    IMG_8474.jpeg
    1.6 MB · Views: 7
  • IMG_8472.jpeg
    IMG_8472.jpeg
    2.4 MB · Views: 7
Good news! The technician has the gen running again!! Turned out it was a 30 dollar kill switch that had failed. Starts and runs as designed🙂

So if you have a similar issue start with inexpensive kill switch.
 
Good news! I will tell you on a seperate issue but same genny, I just had an issue with the genny stopping after 40 minutes of run time. Code 58, exhaust temp, re-routed the sensor and took it out of the system, and runs fine! Ordered a new one, awaiting arrival.
 
You must log in or register to reply here.

  • Tugnuts.com is the community hub for Ranger Tug, Cutwater, and Solara owners. Since its inception in 2008, the Tugnuts forum has grown into an active and thriving community of more than 9,000 members. It serves as both a meeting place for the best boating community online, and an invaluable archive of information.

  • User menu
Back
Top