Seattlejim
New member
- Joined
- Oct 11, 2020
- Messages
- 2
- Fluid Motion Model
- C-288 C
- Vessel Name
- Cascadia
We used a 3” drawer pull from Home Depot and one 8/32” hanger bolt (HD, too). To the left out of photo, the breaker panel can be removed, giving access to the rear of the switch ….to install a screw thought the rear into the right leg of the pull. BUT, note trim on left side of pull…that’s where we used the hanger bolt. BUT, the pull won’t turn clockwise as it hits the trim and switch. SOLUTION: I installed stand offs (one on left and two on right, because of the corner trim on the left). Then, we screwed in hanger bolt through one standoff on the left and screwed a regular, threaded bolt (comes in the bag with the pull) on right from the rear of the panel through TWO stand offs. The standoffs push the pull away from the panel so it can be screwed in place to the hanger bolt. I made the ”stand offs” on the drill press. First, drilled 8/32” hole through 1/4” scrap teak, then without moving the workpiece (so everything stays aligned) cut a 1/2 plug.
