Prop zinc size for Ranger 25

Just Limin'

Well-known member
Joined
Dec 7, 2011
Messages
154
Fluid Motion Model
C-26
Hull Identification Number
2517
Vessel Name
Just Limin'
Wish to install a new zinc on my 2012 Ranger SC. Have 150 hp Yanmar. What size do i purchase?

Thanks
 
If the shaft diameter is 1.25" as it is for a R27 (180 Yanmar) you need a size "D" prop Zn.
 
Go to Boatzincs.com Here is the link. http://www.boatzincs.com/yan120650-13420.html You may want to buy the fitting that will enable you to replace the zinc end only and buy a few replacements at the same time. The bottom zinc tends to deteriorate much quicker than the top zinc.
 
Yes it is a "D" zinc on the 25 also.
As Knotflying suggested you can also get the yanmar zincs. They also carry the thruster and trim tab zincs. I usually order enough for a couple of seasons and get the free shipping.
 
Back
Top