R-23OB Trailer Bunk Diagram

[Craigmconrad]

Hi, I have a Loadrite trailer that I would like to modify to accommodate my R-23. Does anyone have a good diagram of the bunk spacing? I was planning on doubling up 2x6x6 for each main bunk with 48" spacing. Then add two forward bunks close to centerline that are 2x4x4, Any thoughts or pictures would help. The trailer was previously used with a May-Craft 270 PH.

Regards,

Craig

 

[Bruce Moore]

Boat lift drawings for various models, including the R-23, are on this page in the Ranger Factory Technical Bulletins forum.

 

[az9133bm]

Craig,

We have an R23 on a LOAD RITE ALUMINUM AB BUNK MODEL #LR-AB26T6700102LTB. We would be happy to provide you with whatever dimensions you may need.

Ours is set up with Galvanized Steel Bunk-Tube Supports that are unique to LOAD RITE, target bunks up front, and PVC Side Guides truly help "catch and hold" the boat during recovery at the ramp.

We added two additional bunks under the stern (inboard of the factory bunks). We also lowered all bunks 2-1/2" using the adjustable brackets.

George

 

[Craigmconrad]

Craig,

We have an R23 on a LOAD RITE ALUMINUM AB BUNK MODEL #LR-AB26T6700102LTB. We would be happy to provide you with whatever dimensions you may need.

Ours is set up with Galvanized Steel Bunk-Tube Supports that are unique to LOAD RITE, target bunks up front, and PVC Side Guides truly help "catch and hold" the boat during recovery at the ramp.

We added two additional bunks under the stern (inboard of the factory bunks). We also lowered all bunks 2-1/2" using the adjustable brackets.

George

George,

Thanks for the pictures. I stopped by a dealer today and looked at a trailer, it might of been for a cutwater. I'll attached the photos using my phone.

 

[Craigmconrad]

Sent from my iPhone using Tapatalk