R21 EC wiring to mast.

[REO6205]

I'd like to put a couple of work lights on the mast. It looks like the best way would be to run the wiring up through the stripper pole and then to the outside on top of the cabin and then to the mast. Would there be a better way to route the wiring without having a bunch of wires visible all over the top of the cabin?
Has anyone taken the fairing...the one with the faux smoke stack.. off? It's all one piece and doesn't look like a major job to remove. How is the wiring that goes to the cabin top from the stipper pole sealed against water intrusion?
Upon re installing the fairing is there any sealing to be done?
Was it hard to align the holes that fasteners fit into?

 

[Pilotnavigator]

I took my stack section off,not sure why now. But it was simple. You must seal the screw holes very well to prevent leaks into the cabin.
The pole is tight to get more wires in there. Also the head liner must come down to feed the new wires

 

[REO6205]

Thank you. That's a good part of the information I was looking for.