bjp447
Well-known member
- Joined
- Mar 8, 2011
- Messages
- 116
- Fluid Motion Model
- C-24 C (Sterndrive)
- Vessel Name
- Sand Dollar
I have seen some solid tops covering R21, and I am curious if anyone
has any first hand knowledge of how they were made including the supports.
I am just tired of every time after a good rain having to empty the bilge because the
pump only works when it wants to, I think it is a battery thing, I often don't use the
boat for weeks on end. Once I start it the pump works fine. I suspect starting every 2 minutes
runs down the amps on the batteries and it won't start the pump.
I figure covering the boat will stop the problem, plus I gain some room by being able to put sides
on if I want. Any suggestions are appreciated.
I am going to replace the pump with one with a separate switch to see if that helps now that I have
the R21 in my driveway for the winter
has any first hand knowledge of how they were made including the supports.
I am just tired of every time after a good rain having to empty the bilge because the
pump only works when it wants to, I think it is a battery thing, I often don't use the
boat for weeks on end. Once I start it the pump works fine. I suspect starting every 2 minutes
runs down the amps on the batteries and it won't start the pump.
I figure covering the boat will stop the problem, plus I gain some room by being able to put sides
on if I want. Any suggestions are appreciated.
I am going to replace the pump with one with a separate switch to see if that helps now that I have
the R21 in my driveway for the winter