R25 or R27 Build photos

N

nzfisher

Well-known member
Joined
Jan 26, 2009
Messages
592
Fluid Motion Model
C-26
Vessel Name
Swims with Tuna
I think I have seen factory build photos of an inboard R25 or R27 on the site. Could someone direct me to them if they recall where they might be found?

Thanks
swims with Tuna
 
I know they used to build an inboard R27 as my brother has one.
 
Curt
Thanks. Every shot but the one I need showing build before plywood in place at bottom of starboard side lazarette. So it goes.
 
Thanks for everyone’s help with build photos. In particular I noticed how much cleaner wiring and plumbing systems are in Kismet boat than in my R25. Seems wiring was standardized for a larger boat as there are “service loops” everywhere in my boat. If wiring and plumbing were diarrhea, my boat has a bad case- way too much everywhere! The original request was based upon finding out what was beneath the plywood in the starboard lazaret compartment. Since then, I have discovered that you can get the heater out without cutting anything. Well not obvious, but you can pull the heater back to the forward part of the lazaret, prop it up on one of the central stringers, then lift it and rotate it on its axis 90° and it will just barely clear and lift out. For anyone with this heater this is valuable information. Thanks again for everyone’s help.

Swims with Tuna
 
You must log in or register to reply here.

  • Tugnuts.com is the community hub for Ranger Tug, Cutwater, and Solara owners. Since its inception in 2008, the Tugnuts forum has grown into an active and thriving community of more than 9,000 members. It serves as both a meeting place for the best boating community online, and an invaluable archive of information.

  • User menu
Back
Top