Removing Force 10 Stove/Oven

[RobMcClain]

I have a Cutwater 30 equipped with the Force 10 propane stove & oven. I need to remove the unit briefly to access the area behind it. Has anyone done this, and if so any words of wisdom to provide?? I need to replace the propane sensor that is in the cabinet under the oven and I cannot access the wiring harness as the wires to the sensor are secured in some manner. I’ve been advised by the factory to remove the stove/oven, and that doing so will provide the needed access. I’ve also been told it is a relatively easy job, just one that requires cautious methodical hands. I just curious if anyone has done this?

Rob

 

[sd1209]

Rob--I've got a Ranger Tug 27 with a Force 10...I bet they come out the same way.....On mine, there are 4 screws just inside the door....Open the door and the 4 screws are recessed a bit but very visible and easy to get to......Two on each side.....I took mine out recently to replace the AA battery for the spark...It's really a 5 min job to pull the stove...While in there, replace the AA battery also.....Crazy to have to pull the stove for these rtn maint items.........

 

[RobMcClain]

I’ve seen the screws you are describing. Sounds like a job I can do! Thanks….