jswhal
Active member
- Joined
- Oct 18, 2016
- Messages
- 43
- Fluid Motion Model
- C-24 C
- Non-Fluid Motion Model
- Cutwater 28
- Vessel Name
- Sea Glass
There is a 2 pin connector in the wire harness on the reverse gear that is not connected on my C28. It's got a red label reading "Rev. Sensor". There are two more connectors labeled A and B that are plugged in. I don't see any place to plug it in. Is this something that's not used? Boat operates normally. (Wish I could figure out how to embed pictures here!)