trim tabs

J

Jerold Geisenheimer

Well-known member
Joined
May 26, 2010
Messages
61
Fluid Motion Model
C-288 C
Hull Identification Number
FMLt2919c909
Vessel Name
Joint Venture
I am thinking about installing the automatic Benett trim tab assembly on my Ranger R29. Has anyone had experience with this addition and is installation fairly easy? If so, where would be a good location? As the trim tabs now function there is no way to know their position so I am thinking this would be a big improvement.
 
Jerold Geisenheimer":icvg8fw0 said:
I am thinking about installing the automatic Benett trim tab assembly on my Ranger R29. Has anyone had experience with this addition and is installation fairly easy? If so, where would be a good location? As the trim tabs now function there is no way to know their position so I am thinking this would be a big improvement.
Click to expand...

This one?
AC3000.jpg


Mine's still in its box but it's fairly high up on my project list.
On my C28 the control box is going in the locker under the helm seat.

Like you, I wanted to know the tab positions at all times so the easiest solution was to install the Bennett TPI (Tab Position Indicator).
TPI2000_display.jpg


Shown here installed above the searchlight and thruster controls:
5p4emo.jpg
 
You must log in or register to reply here.

  • Tugnuts.com is the community hub for Ranger Tug, Cutwater, and Solara owners. Since its inception in 2008, the Tugnuts forum has grown into an active and thriving community of more than 9,000 members. It serves as both a meeting place for the best boating community online, and an invaluable archive of information.

  • User menu
Back
Top