Upgraded cockpit table on R27OB

[johnbenj]

Just finished replacing the factory table pedestal with the Garelick Quick Release pedestal. It was a simple project and the table is much more stable now.

Here is a link to the unit on Amazon:
https://www.amazon.com/gp/product/B00144732Y/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1

There is a picture in the photo album but it is a vanity shot really and doesn't show much detail. If you search TugNuts there are other threads about this upgrade .

 

[yorangerjim]

Any photos

 

[johnbenj]

Any photos

I updated the original post with a link to Amazon and there is a picture on my photo album now.

 

[BB marine]

Just finished replacing the factory table pedestal with the Garelick Quick Release pedestal. It was a simple project and the table is much more stable now.

Here is a link to the unit on Amazon:
https://www.amazon.com/gp/product/B00144732Y/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1

There is a picture in the photo album but it is a vanity shot really and doesn't show much detail. If you search TugNuts there are other threads about this upgrade .

This upgraded pedestal works well on all models of Fluid Motion. The original base used by Fluid Motion had the wobbles. I installed the base in place of the original and made a smaller table top to go with it. C26, C28, and outboard model Tugs and Cuts this is an upgrade to the original install. It is good that you discovered the same solution and passing it on.
gallery2.php?g2_itemId=47221&g2_imageViewsIndex=1

There was a thread a couple of years ago about the use of this base and pedestal.viewtopic.php?f=2&t=11110&p=76781&hilit=table+pedestal#p76153