V-berth ambiance lights not working

[CGW]

RT 31CB
The LED strip lights below the bed are not working.
Where do the wires go once they exit through a hole in the fiberglass?
The wall switch won’t pull out to test for power because the wires seem too short.
Suggestions?

 

[AKSTEVE70]

Great question. I’m having the same issue only 2012 R29 Ranger Tug. If I figure it out I’ll post on this thread.

 

[CGW]

I’m 90% certain that the wire is disconnected at the light switch but there is not enough slack in the wires to pull the switch out far enough to re-attach it. I am cautious not to disconnect the main lights as it could be really a problem if the wires fell into the wall there.

 

[T@U-LUSA]

I'm looking at your owner's manual, pages 11 and 33.. It looks like they draw power from your V-berth lights.
Check your DC breaker to make sure that V-berth Lights breaker is not tripped.
The wires for the light should run down the starboard side. Power should be blue with a white stripe, ground yellow.
There should be a hatch or drawer that lets you see inside the bed pedestal.
If the other V-berth lights work, then it is most likely a loose ground.

 

[T@U-LUSA]

I'm looking at your owner's manual, pages 11 and 33.. It looks like they draw power from your V-berth lights.
Check your DC breaker to make sure that V-berth Lights breaker is not tripped.
The wires for the light should run down the starboard side. Power should be blue with a white stripe, ground yellow.
There should be a hatch or drawer that lets you see inside the bed pedestal.
If the other V-berth lights work, then it is most likely a loose ground.