Where is the air conditioner water pump splice on the R25

[captstu]

The air conditioner water flow on our 2010 R25 stopped working.

It is several years old and shows signs of salt seepage, so I'm ready to replace it especially since it shows no current draw when power is applied.

The wire from the pump is black on the outside while the other end is white jacketed - indicating a splice.

Where is the air conditioner pump plugged in?

If I can find this splice, I'll replace it with a waterproof plug/socket when I put in the new A/c.

Thanks

 

[Levitation]

Knowing Ranger, the butt connection on the AC wires will be somewhere between the cabin liner and the outer hull. Well hey, the splice was right there handy when the cabin was still suspended a foot above the hull, eh.
Turn on the power to the AC and using sharp probes check that you have voltage on the wires at the pump.
Assuming you do, then cut the wires close to the pump and change out the unit.
For electrical hookup you can cut the excess wires off (or coil everything up) and put the plug inside the cabinet next to the new unit.
Actually I would skip the plug. You can leave enough extra wire to be able to cut and splice as needed in the future.