Wine cooler removal

[bevis]

How can we remove our wine cooler from our RT31?

 

[Automaticman865]

Hi,
on my Cutwater there is a panel in the aft cabin covered with the rug material. Remove the screws there should be an L bracket with a few screws holding the back of the cooler in place.

Stuart

 

[Tug Travelers]

Hi, I did the exact same thing on our 31. As was previously said you need to get access to the back of the wine cooler. I think there were two little l brackets with very short screws holding the wine cooler in. The hard part is you need to remove the back of the midberth cabin, which is not hard. But the screws are up above where the access panel is removed. I don't think I could actually see the screws.

Once those screws are out the fridge comes right out the front. It was a real puzzle until I found those little screws.

Good Luck! Let me know if you have any other questions.

John

Tug Travelers

 

[Bart Keil]

On our 2011 R29 S, The wooden spacer blocks under the L brackets had to be unscrewed. I founf that each had been screwed to the bottom of the wine cooler from below. I left the L brackets attached and pulled the unit out with the wooden blocks attached. I have pics if needed.