Latest activity
-
JJared Dunning replied to the thread Boat (Hull) plugs.Yes, both the engine pod and main hull drain plugs are the same size and type. They use 2-inch bronze garboard drain plugs. You can...
-
GGwkessel replied to the thread 2016 yer model,c-30cb.Hi Ralph, The old panel/controller is no longer in production. Theford/Tecma recommends replacing with newer part. Purchase the...
-
JJared Dunning replied to the thread Ranger Tug r-23 inverter Reset.I would recommend having the technician go through the boat and thoroughly inspect the wiring. It sounds like something may have been...
-
Submariner replied to the thread Organizing.LaZina walks through our galley and shows how she organizes our R27. -
OverTime replied to the thread Organizing.I like the way the coffee cups ride here. The whiskey bottle was a gift, it started leaking immediately! Luckily, I had only put tea in... -
-
I have a 2017 R29 Sedan and got the following from Tim Bates back in 2020 when I asked him about the rudder grease fitting: "Concerning...
-
This is a grease fitting and uses a needle adapter. On mine the fiting was frozen so I just unbolted the knuckle and greased it by hand...
-
BBosn Mate replied to the thread lubricating rudder arm.I have a 2017 R29 Sedan and got the following from Tim Bates back in 2020 when I asked him about the rudder grease fitting: "Concerning...
-
This is a grease fitting and uses a needle adapter. On mine the fiting was frozen so I just unbolted the knuckle and greased it by hand... -
Todd Tugnut replied to the thread ePropulsion for Ranger Tug Dingy?.We liked our epropulsion with our Ranger inflatable. Easy to set up and stow. No gas or oil to worry about. So quiet to use. Spring... -
SKing replied to the thread lubricating rudder arm.This is a grease fitting and uses a needle adapter. On mine the fiting was frozen so I just unbolted the knuckle and greased it by hand... -
MMastercraft replied to the thread lubricating rudder arm.My 2017 R29 has a regular grease fitting. Yours looks different. Right or wrong, I did not think much about it and pumped water proof...
-
OverTime replied to the thread Starlink Mini Installed to Replace TV Antenna on 2019 R-29 CB?.Here's my setup. I wired it to to the accy. switch (I swapped it out for a branded Starlink switch) on the CB dash. I used a small step...
-
-
OverTime replied to the thread lubricating rudder arm.Is this for oil? Grease? How do I lube it? Thanks.
-
AA&Etug replied to the thread Ventilation.Always welcome to stop by if you get up in the area-we are at Catawba Moorings enjoy the keys!
