ask the factory archive - ranger

  1. W

    2018 Ranger Tugs R23 6YC tank calibration override?

    I had to replace the 6YC Yamaha display / control unit on our 2018 Ranger Tug R23 (outboard). Because it is a new unit, I need to do an initial set-up, however, in order to calibrate the gas tank levels, it wants me to start with an empty tank and as gas is added at 15 gal intervals, it is set...
  2. A

    Interior Wood, 2024 RT 27 OB

    I have watched the spring maintenance video about restoring interior wood on a Ranger Tug and understand that some of the wood has Minwax Helmsman urethane and the rest of the wood is treated with Daly's Seafin teak oil. Couple of questions about our 2024 RT 27 ob: 1) It appears that the Galley...
  3. M

    Replace house bank with Lithium batteries

    I have 2023 ranger tug 25OB with standard battery configuration 2 house 1 started 1 thruster Is it ok to replace floater house batteries with Lithium batteries. with the same AH 100 each and then set the ABSO charger to the correct setting?. My ABSO is a 20a 1220 model. Does any thing...
  4. S

    R29 classic Replacement cabin reading light? maker? Model?

  5. S

    Leather trim Lining material

    Thanks to Tugnuts, I've found that trim leather is BEL3315 Softside Beluga Marine Vinyl Mocca. What is the lining material under this leather?
  6. C

    Where do all the cushions go?

    Is this how the two bow seat cushions go? The top cushion fits nicely into the lid but can’t seem to get the snaps to attach. The bottom extends past the snaps. The top can’t close with the bottom in place.?? I was hoping to store the cushions in place. Where does this sloped cushion go?
  7. S

    LED Nav and Anchor Lights

    Can anyone tell me where to purchase LED navigation and anchor lights for a 2022 R31CB? As well as the part numbers if known.
  8. K

    Kicker

    2021 R27 outboard; buying/installing a yamaha 9.9 kicker. What is the shaft length I need and related components?
  9. ECR

    Hatch Window Cracked on Corner

    Hello, We have a 2017 R25 and the Hatch Window above the sink is cracked in the corner and leaking water. Is it possible to replace just the top piece that opens? And/or any suggesting on a silicone that might be a good sealant? Not sure who manufactures the window - is that something you...
  10. B

    Looking for Garmin Course Computer on a 2014 R29.

    Hello. I need to update the course computer (2 connectors) with a Rector 40 unit so it's compatible with my new 8616 and GHC 50. I thought it would be located in the lower quarter berth but didn't find it there. The wiring from the GHC to the auto pilot module (4 connector) and pump goes along...
  11. P

    Interior light Mfg or Part No? - 2016 R-29 S

    I am looking for the manufacturer or part number to source a replacement 12 volt LED on my 2016 R29s. This one, located above the head's mirror, took a bunch of trapped water from a leaking porthole exterernal seal. It fought valiantly but mother nature always wins.. Any assistance would be...
  12. 5

    Potable water tank level indicator on r27 classic 2017

    gauge is stuck at 3/4 tank despite filling and empty for a few to see if would fix itself. I can find a new gauge for $21 but I suspect it might be the float part. How do you get access to the water tank to check or replace float. thank for your help Steve
  13. T

    Starlink installation.

    Please provide some guidance for routing the Starlink antenna cable from the aft cockpit roof into the space above the cabin ceiling. We can find a route from there. Believe me lots of Tugnuts will be asking this in the future. We just don’t want to make too many mistakes before finding the best...
    • TXTUG
    • Thread
    • 2020 model year ask the factory archive - ranger electrical general questions r-31 cb
    • Replies: 1
    • Forum: Ask the Ranger Factory
  14. G

    After market AC install?

    Hi, in the process of purchasing a 2019 Ranger Tug R23 that comes with heat rather than AC. Is adding aftermarket AC a thing? Thanks for helping out a noob. Oh, and I'm in Massachusetts if that matters.
    • gwen
    • Thread
    • 2019 model year ask the factory archive - ranger customizations
    • Replies: 1
    • Forum: Ask the Ranger Factory
  15. AGLyme

    2013 R31cb

    Dear factory, Can you please let me know where the Garmin CCU is located on the boat ? This Easter egg hunt for the little black egg is (too) hard All original from the factory Garmin gear (2013 era, 5215 CPlotter), the Auto Pilot is a GHC-20. It’s not attached to the bulkhead beyond the...
  16. mlanger

    Timed Bilge Pump Not Automatically Running

    I have a 2019 R-29 CB with one of the 6-minute (I think) timed bilge pumps installed. Recently, it stopped running automatically. It does run, however, when I turn it on manually with the switch at the helm. Is the bilge pump broken and requiring replacement or are there some troubleshooting...

  • Tugnuts.com is the community hub for Ranger Tug, Cutwater, and Solara owners. Since its inception in 2008, the Tugnuts forum has grown into an active and thriving community of more than 9,000 members. It serves as both a meeting place for the best boating community online, and an invaluable archive of information.

  • User menu
Back
Top