2024 model year

  1. B

    AC Condensate Build Up

    Hi Team, New 2024 Ranger Tug R-25 with what I believe is excessive Webasto condensate building up. So much so that it is sloshing out underway and leaking into cave. See photos below and video here... https://drive.google.com/file/d/1mO2-tOLCVK8Jamubp7_A3VAln2l4Cq6B/view?usp=drivesdk
  2. R

    Water under V-berth

    We have been getting a substantial amount of water collecting under the V-berth of our 2024 R-31 CB. It is not coming from the shower sump (haven't used the shower this season). I suspected an anchor locker drain blockage, but it's clear. The most water seems to accumulate after a rain...
  3. L

    No house power

    I’m sure this has been asked before but I can’t locate it. I have a 2024 RT27 OB LE I got to the boat today and I have no house power. Shore power works for the outlets but nothing else works. I did notice the GFI in the mid berth wasn’t working and neither the test or reset button do anything...
  4. A

    Interior Wood, 2024 RT 27 OB

    I have watched the spring maintenance video about restoring interior wood on a Ranger Tug and understand that some of the wood has Minwax Helmsman urethane and the rest of the wood is treated with Daly's Seafin teak oil. Couple of questions about our 2024 RT 27 ob: 1) It appears that the Galley...
  5. P

    Hose from Strainer Piping to Shaft Coupling

    I was filling the engine fresh water strainer while the boat was on the hard and the seacock was closed I noticed that the water kept draining out. I then noticed that water was running out around the prop seal on the exterior. I then found there is a hose from the under side of the strainer...
  6. JMarshallR25

    Victron BMV-712 Battery Monitor Settings

    What settings does the factory recommend for the Victron BMV-712 on an R25 with 600 AH of Dakota lithium batteries in order to obtain accurate readings of time remaining, percent consumed, etc.? Currently, the monitor is providing inaccurate readings and generally showing 100% charge at all...
  7. W

    R23 2024 trim tab model

    I have a 2024 R23 (HIN FMLT23071324) outboard with a 200HP Yamaha and a 9.9HP kicker. What Lenco trim tabs were installed on this boat. These trim tabs have no zinks. Why are there no sinks? I would appreciate the model number of these trim tabs and actuators. Thanks
  8. Hensch42

    Bilge pump automatic

    On a 2024 R27 OB LE. During a Courtesy Coast Guard inspection, noticed that the bilge pump would not check on the 2.5 min cycle when all power was off. It did OK when on House Battery. What should I be checking? Is there a fuse associated with?
  9. P

    Vent for waist water tank

    Hello, I have issues flushing the head. A lot of pushing back pressure, which means it has difficulty leaving the head clean after a flush, so I am suspecting the vent for the waist water tank being plugged. How do I unplugg it? I have removed the hose from the tank and tried to push through a...
  10. P

    Speed of 2024 Ranger Tug R29 CB LE?

    Hello, I seem to not reach the speeds I hear others achieve or that is on the spec sheet. My max speed (fully trimmed nose down) at 3550 rpm is 17 knots and crushing speed at 3000 rpm is only 12.5-13 knots. From the spec sheet I understand it should be 23 knots at 3700 rpm and 15 knots at 3000...
  11. R

    Replacement drawerfront/door

    I have 1 door and a drawer front in the galley that have deep scratches/gouge that are too deep to sand. How can I order a replacements? (2024 27 LE) Thank you.
  12. P

    Remote thruster receiver location on a 2024 R29 CB LE?

    My remote controller of the thrusters has lost connection with main base ( receiver/ transmitter). I need help locate the main base in the boat so I can pair it again? Can you help? I looked many places but no success. I also had a thread on the general discussion assuming others would have...
  13. B

    New Owner - Unusual Reflection In R-23 Windshield

    I've just joined Tugnuts and this is my first post. I recently purchased a new R-23 and have been really enjoying the boat so far!! I do have a concern with my starboard windshield, which gives an unusual reflection of subhorizontal lines when it's sunny out (see attached photos). I...
    • BB Cruiser
    • Thread
    • 2024 model year r-23 (outboard)
    • Replies: 7
    • Forum: Chat
  14. A

    2024 R-27 zincs for bow thrusters and trim tabs

    Are zincs needed for the bow thrusters and trim tabs? If so, how are they attached?
  15. M

    2024 Ranger Rug R31S Propeller

    I am looking for the propeller brand, part number, nut, sheer pin for a 2024 Ranger Tug Prop. I see other threads and called Acme Prop but they said to double check for the 2024 model.
  16. P

    R29 LE Hot Water Tank Winterization

    I have a new 2024 R29 LE and wanted to drain the hot water heater. Some of your materials indicate the tank has a drain valve. I accessed the tank in the cave and removed the panel only able to view the end of the tank. There are numerous PEX/PVC hose fittings and one Stainless Steel hose...
  17. M

    2024 Ranger Tug R31S Winterization

    I have reviewed all the tugnuts / ranger tugs videos and you tube videos etc and when winterizing all I see is everyone turning the seacock for the main Volvo D4 off and filling the strainer with RV Antifreeze and running engine. But this does not feed into the AC or Generator..... How do I...
  18. JMarshallR25

    2024 LE MPPT

    It appears that 2024 LE models are including what looks like an EPEVER DuoRacer MPPT Dual Battery solar charge controller instead of the old MorningStar SunSaver Duo. This product is visible in the "cave" in user Submariner's R25 tour video from the 2023 Seattle Boat Show. What is the incoming...
  19. pdo

    Inverter Question

    I have a new 2024 C288 with the lithium batteries. When I go off shore power to inverter the hot water heater will no longer work. Everything else operates fine, other than the hot water heater. I understand that the hot water heater is a big energy draw, so I normally turn all other things like...
  20. M

    Bow Railing Modification

    In Long Island there are no finger piers so if you have the Dinghy Lift one has only one option to pull into your own slip or visit a marina in my area and that is bow first. Since the rail on the Ranger Tug 25 OB is very high it is difficult to get on board. I modified the bow rail by placing...

  • Tugnuts.com is the community hub for Ranger Tug, Cutwater, and Solara owners. Since its inception in 2008, the Tugnuts forum has grown into an active and thriving community of more than 9,000 members. It serves as both a meeting place for the best boating community online, and an invaluable archive of information.

  • User menu
Back
Top