r-31 cb

  1. S

    Wiper motor for 2022 31CB

    Is the wiper motor for a 2022 Ranger Tugs 31CB a Marinco part number 36161, AFI 1000. 65 deg 1 1/2” shaft as you replied recently to another post on another model manufactured by your company? Or, is it a different part number and spec, and if so, can you please let me know? My motor failed...
  2. H

    R31CB Inverter fuse

    Where is the inverter fuse located on a 2018 R31CB?
  3. R

    Major leak

    I am the relatively new owner of a 2019 R-31. On our maiden voyage a few weeks ago, in rough seas, we noted a major leak coming from the area of the overhead of the stairs going down to the main cabin. We were taking pretty good seas striking the windshield. Later, to isolate the leak i directed...
  4. T

    Starlink installation.

    Please provide some guidance for routing the Starlink antenna cable from the aft cockpit roof into the space above the cabin ceiling. We can find a route from there. Believe me lots of Tugnuts will be asking this in the future. We just don’t want to make too many mistakes before finding the best...
    • TXTUG
    • Thread
    • 2020 model year ask the factory archive - ranger electrical general questions r-31 cb
    • Replies: 1
    • Forum: Ask the Ranger Factory
  5. O

    2019 R31 CB - Head Sink Seal

    I need to know the manufacturer and part number for the seal around the stopper on the sink in the head of our 2019 R31CB. The original seal has disintegrated and it appears to be a special flapper seal not readily available. Without the seal the sink will not hold water. Thank you Keith
  6. F

    R31CB engine hatch warping around edges

    The hatch cover edges don't seal, so they drop down when you step on them, and the whole hatch vibrates like mad. What can be done to fix this? Thanks!
  7. M

    Lenco trim tabs

    Hi Guys Was under way and went to lower the trim tabs. Didn't notice the branch stuck in the starboard tab. Needless to say it didn't lower. I'm assuming it blew a fuse. I don't hear the motor when I try to lower or raise that tab. The port side woks fine. I tried to follow the wiring but don't...
  8. S

    31CB new Victron charger/inverter wiring issue?

    My 2022 CB31 charger/inverter stopped working a few weeks ago, so my boat electrician removed it and installed a new 3000 watt Victron charger/inverter, which works on generator and shore power for a few seconds and cuts out, and continues to cycle in and out every few seconds. The inverter...
  9. G

    Maximum Weight Recommendation for Dinghy on Weaver Davits

    The prior owner of our 2021 R-31 CB, equipped the boat with a 165 lb RIB on 4 up and 4 out Weaver Davits, along with a 90 lb 9.9 outboard handing on the stern rail. I already swapped the 90 lb engine for a 56 lb 6 hp, but I am suspect that the 150 lb dinghy is affecting the performance of the...
  10. G

    Tecma toilet holding tank sensor stuck on red

    On our 2020 R-31 our forward head toilet tank sensor is malfunctioning. It either goes from green to red randonly then remains red with the unlock button unlit even with the holding tank completely empty. Also the method for overriding the lockout is not working. Does anyone know of a solution.
  11. G

    Tecma toilet water use and plumbing for salt vs fresh water

    How much water does the tecma toilet on my 2020 R-31 use per flush? Does you have an information or experience with changing the toilet from fresh to salt water use?
  12. T

    NMEA2000 Location and Diagram

    Is it possible to get a diagram of the NMEA 2000 layout and location of terminations for a 2020 R31CB. It would be very very helpful. Also the best way to access these locations.
  13. G

    Dinghy for 2020 R-31CBtomca

    What is the largest dinghy in size and weight that the 2020 R-31CB is designed to carry?
  14. F

    R31 Aft Refrigerator Power

    Hi - the 2021 R31CB I got has the cockpit refrigerator, but at times it won't run, and I suspect is't one of the 12v switches. There is an Isc Maker switch on the panel, and one of the Accessory switches lights when flipped, but I haven't yet been able to determine exactly wht controls it. Can...
  15. M

    Low oil level sensor alarm

    Hi there, have had this issue the past 2 years. When running WOT sometimes I get an alarm from the Volvo penta, low oil level sensor. I’ve had the oil changed the end of last season and only put about 35 hours since the oil change. Got plenty of oil on the stick. Could it be a faulty sensor...

  • Tugnuts.com is the community hub for Ranger Tug, Cutwater, and Solara owners. Since its inception in 2008, the Tugnuts forum has grown into an active and thriving community of more than 9,000 members. It serves as both a meeting place for the best boating community online, and an invaluable archive of information.

  • User menu
Back
Top