D6 engine zinc -- what tool?

Status
Not open for further replies.
M

macnmm

Member
Joined
Jan 27, 2014
Messages
15
Fluid Motion Model
C-24 C
Non-Fluid Motion Model
Cutwater 30
Vessel Name
Luminosity
MMSI Number
367620120
I need some tool advice! I tried everything I have (regular wrenches) but that forward engine zinc is sure hard to get a purchase on. What do you guys use? Should I buy a 13 mm 8-pt socket and an extension? Or is there some other thing you would use that reaches in there? The rear one was a piece of cake with my 13 mm open-ended wrench but no way could I get the right angle on the other one.

--Nat
 
Good Morning Nat,
I use a mac wrench off set 13 mm to get the fwd engine zinc off. You can find these on any tool truck or sears craftsman tools.
 
Status
Not open for further replies.

  • Tugnuts.com is the community hub for Ranger Tug, Cutwater, and Solara owners. Since its inception in 2008, the Tugnuts forum has grown into an active and thriving community of more than 9,000 members. It serves as both a meeting place for the best boating community online, and an invaluable archive of information.

  • User menu
Back
Top