ELCI Location C26

Status
Not open for further replies.

scubabob

Active member
Joined
Sep 12, 2015
Messages
37
Fluid Motion Model
C-26
Non-Fluid Motion Model
Cutwater 26
Vessel Name
Pocket Edition
I bought a Cutwater 26 through Bellingham Yachts from another party and we are unable to locate where the ELCI (Equipment Leakage Circuit Interrupter) Is located on this craft. It is hull #20 built for the 2012 model year.
I thought it would be near the shore power plug is. Mark of Bellingham said that he'd seen it under the microwave stove. No luck in either place. Any ideas of where else to look?
Bob
 
On my 2012 Cutwater 28 just inside the cabin door, on the port side. There is a small door which is below my oven, and the hinges almost sit on the cabin sole. ELCI is located way inside on the back wall. I have to lay down on the floor to reset it.
Stuart
 
Hey there Bob,

The ELCI breaker is indeed under the stove in the storage cabinet.

Thanks Bob,
 
Good morning Bob,
We have a 2012 26 Cutwater that we bought used & ours is also located under the microwave, you have to open the hinged teak door & lay down to get to it, it's all the way back almost to the hull.
Hope this helps?
Mike
M/V Elan
180 hp Yanmar
 
Thanks all! Will get thin an tiny to find it.

Fair winds, etc.
 
Can anyone tell me where the ELCI is on a R25--2009 version? Thanks.
 
What is an ELCI?. I know it is under my oven, but what does it do?
 
Equipment Leakage Circuit Interruptor. Similar to a GFCI but designed for your whole boat. Looks for a 30mA difference in current between the hot and neutral and if so breaks the circuit.
 
Status
Not open for further replies.
Back
Top