Latest activity
-
BBlue Frog replied to the thread 2017 RT27 Water Pressure Not Working.Thanks to everyone for your help. We were up in Princess Louisa Inlet without cell service. Managed to get to the root of the problem...
-
Ok. Now let’s calculate your scope. Assume worst case factors. 16 feet depth was at low tide. At high tide depth would have been 19... -
Adam replied to the thread Outdoor Rocker Switch / Lighting Issues 2024 R025.Quick update, I ordered the switches that jrmarshallr25 posted, thanks! I found them at Amazon and they were an exact replacement... -
Vvenajeff reacted to MichaelStrotz2's post in the thread Tug and cutwater boat photos for book with
Props.
Here is a photo of my foxhound in the hatch of my 2008 Ranger Tug 21-EC. This photo won first place in Ranger Tug's photo contest of... -
It doesn't happen often, but on rare occasion when my Rocna is stuck, I will bring it up as much as I can, and then will tie off the... -
MMichaelStrotz2 posted a comment on the media item 21 Ranger Tug 20.On my 21' there is a standard 120 V electrical plug mounted right there on the inside of the engine cover. I plug my extension cord...
-
MMichaelStrotz2 replied to the thread Tug and cutwater boat photos for book.Here is a photo of my foxhound in the hatch of my 2008 Ranger Tug 21-EC. This photo won first place in Ranger Tug's photo contest of...
-
-
No reasonably sized anchor will hold under "any conditions." You could lash a 100 pound anchor to the foredeck and that might increase... -
It doesn't happen often, but on rare occasion when my Rocna is stuck, I will bring it up as much as I can, and then will tie off the...
-
There is a big problem with the Rocna though. If you anchor in mud (eg Garrison Bay) it can sink/set so far down into the mud that it is...
-
You would have the local knowledge. Seems lot of west coasters make that change..
-
Most of what I see in the Pacific Northwest, all the way north into SE Alaska, folks who anchor a lot upgrade to the Rocna. I don't...
-
Submariner replied to the thread Anchor issues.It doesn't happen often, but on rare occasion when my Rocna is stuck, I will bring it up as much as I can, and then will tie off the... -
-
scross replied to the thread Anchor issues.There is a big problem with the Rocna though. If you anchor in mud (eg Garrison Bay) it can sink/set so far down into the mud that it is...
-
Ralf H replied to the thread pod filling up on Cutwater 32.Forgot to mention! Don't leave the ten amp fuse for your bilge pumps. Change them back to the 7.5. They're rated that for a reason. If...
