2023 model year

  1. B

    R27 OB fuel tank shifting?

    2023 R27 OB LE, HIN FMLT2735I223. The fuel tank appears to have shifted forward about a 1/2” based on seeing a gap between the tank and the bulkhead aft of the tank and seeing evidence of the fuel fill and fuel line hoses being shifted forward from their original cable tie fixations. I can...
  2. P

    Access Lithium house batteries on Ranger Tug 43

    HIN: FMLT4302H223, 2023-model year, Ranger Tug 43 CB 1. Is the access to the house batteries through the panel behind the toilet in the aft head? 2. In installing a Sensar Marine system, do you have a recommended location for the Sensar unit?
  3. Nwdiver

    Windshield wiper motor replacement for c-288

    My port windshield wiper failed last night, right in the middle of a nighttime cruse on the Columbia river. The symptoms were a little odd and very concerning. I was using the wipers intermittently for about an hour when the wiper travel reduced by about half, then eventually stopped...
  4. Nwdiver

    C288 120V AC schematic

    Is there a schematic available for how the 120VAC is wired on the c-288? I am confused about what circuit breakers are connected to the inverter. Ed
  5. Adam

    No power to Garmin Chart-plotter 2023 R25

    Hi factory team! On our last cruise, all systems worked great and we came to port and shut everything down normally. We returned for a cruise a month or so later and our chart-plotter was non-responsive to the power button. I've checked power output from all the fuses on the panel mounted to...
    • Adam
    • Thread
    • 2023 model year electrical garmin r-25 (outboard) troubleshooting
    • Replies: 22
    • Forum: Ask the Ranger Factory
  6. Nwdiver

    Fog horn on c-288

    What is the foghorn manufacturer and part number on 2023 c-288
  7. D

    2023 R27 OB Shower-head

    Anyone have the Manufacturer and model # of the handheld shower-head in the head of the R27OB (2023). Dopey me disassembled it chasing a leak and can’t get it back together correctly. Thanks!
  8. curtisgeiger

    2023 R-23 Fuse Location

    I am trying to troubleshoot why my deck and underwater lights will not turn on. Was going to start with the fuse but cannot locate. Can some on the mothership provide some assistance? Curt
  9. curtisgeiger

    Downrigger Prewired for R23

    I can see in the cave fuse block there are two fuses marked for downriggers. Can you tell me if wires have already been pre-run and coiled somewhere below the deck? I don’t see anything that jumps out at me.
  10. S

    How long should the Air-Conditioning last on the R-25 SC with Lithium

    Hello, When cruising with the outboard running and the lithium battery pack, how long should we expect the air-conditioning to last before it shuts off due to a lack of sufficient power? We have a 2023 R25 SC with the Lithium battery pack option. Thanks Steff
  11. J

    Source for light fixture above dinette in the Cutwater 32C (2023)

    Can you please send the part number and source of the light fixture in the dinette? I understand that your parts department is moving, but we are trying to replace the light fixture due to excessive rusting on the metal part. It is disappointing that it is severely rusted in a boat that is less...
  12. curtisgeiger

    R-23 New Kicker Motor Setup and Install

    I have a 2023 R-23 with a factory installed kicker motor mount. I also have a brand new 25HP Yamaha long shaft looking for a good home. Would like to put the 25HP on the boat - but not sure what the best course of action is for steering controls. I sure wish I could take advantage of the...
  13. curtisgeiger

    Steering Hydraulic Hose

    These are a couple photos of the factory installed hydraulic hoses on the 200HP Yamaha outboard. One photo with motor up and one with motor down. The bend in the hose is concerning to me. What actions do you recommend? Curt
  14. curtisgeiger

    Installing a New Kicker Motor on R23

    I have a 2023 R23 with a kicker motor mount that was installed at the factory as an option. I have new Yamaha 25HP with a 20" shaft and electric start. Would like to rig up the 25HP and tie it to the 200HP so that I can use the autopilot. Can you tell me what steps I need to take to do this...

  • Tugnuts.com is the community hub for Ranger Tug, Cutwater, and Solara owners. Since its inception in 2008, the Tugnuts forum has grown into an active and thriving community of more than 9,000 members. It serves as both a meeting place for the best boating community online, and an invaluable archive of information.

  • User menu
Back
Top