r-23 (outboard)

  1. F

    small part needed

    I have a R-23 2023 and need a new wiper switch. How can I find it?
  2. T

    Folding radar tower

    I was told that Ranger Tugs have a folding radar tower and I wondered if there were pictures of one and where I might source one. Thx, TC
  3. curtisgeiger

    Downrigger Prewired for R23

    I can see in the cave fuse block there are two fuses marked for downriggers. Can you tell me if wires have already been pre-run and coiled somewhere below the deck? I don’t see anything that jumps out at me.
  4. S

    Shore power issue 2021 R-23

    My 2021 R-23 with lithium ion battery upgrade was found to have a dead house bank and fully charged engine and thruster batteries while stored on the trailer and plugged into shore power. I used a outlet tester to confirm proper wiring, and measured voltage on the female end of shore power cable...
  5. S

    Shore power issues

    My 2021 R-23 with lithium ion battery upgrade was found to have a dead house bank and fully charged engine and thruster batteries while stored on the trailer and plugged into shore power. I used a outlet tester to confirm proper wiring, and measured voltage on the female end of shore power...
  6. curtisgeiger

    R-23 New Kicker Motor Setup and Install

    I have a 2023 R-23 with a factory installed kicker motor mount. I also have a brand new 25HP Yamaha long shaft looking for a good home. Would like to put the 25HP on the boat - but not sure what the best course of action is for steering controls. I sure wish I could take advantage of the...
  7. curtisgeiger

    Steering Hydraulic Hose

    These are a couple photos of the factory installed hydraulic hoses on the 200HP Yamaha outboard. One photo with motor up and one with motor down. The bend in the hose is concerning to me. What actions do you recommend? Curt
  8. curtisgeiger

    Installing a New Kicker Motor on R23

    I have a 2023 R23 with a kicker motor mount that was installed at the factory as an option. I have new Yamaha 25HP with a 20" shaft and electric start. Would like to rig up the 25HP and tie it to the 200HP so that I can use the autopilot. Can you tell me what steps I need to take to do this...
Back
Top