R23 rear door latch / catch - black , semi-hard 1 x 1 1/2 x 1/2 block - does anyone know what this material is ? It failed last weekend and I need to replace the black , block material - I just don't know what the material is ..it's seems to be a semi-hard nylon or hard rubber material ..any...
We have a 2024 R-23 and recently purchased a Sharrow prop in hopes of improving performance and fuel economy. I went to fit the new prop and found that it will not clear the anode (see pics). So, is it ok to trim the anode or should I replace with a flush version. I'm seeking input from Ranger...
Ranger Tug 23 HNFMLT23281920: the white coating on the cabin-top hatch frames is peeling off. What is the frame material? Can it be lightly sanded and repainted? What paint should be used? Thanks.
I have a 2020 Ranger Tug R-23 and just did a battery turnover after one battery went bad with ozone release. Afterwards the inverter toggle switch won’t work and the thruster won’t turn on. The I checked the circuit breakers in the starboard and port lazarette and they were fine. The shore power...
I've been trying to troubleshoot the AC panel on our (new to us) R-23 (FMLT2309F920). The shore power input breaker does not have a green led light, but seems to behave normally otherwise. The voltage is normal at the outlets (120) and the ground fault sensing module is happy (green light...
The trim along the bottom of the windshield on my 2019 R-23 is coming off as shown in the attached photo. What is the correct adhesive to use to fix this?
I have a 2017 R23OB. I understand that there is no tilting dinghy rack for this model, but what about it doesn't fit the R23? Is it something I can modify on my end? I have metal fab capabilities, but I'm thinking it might be easier to start with the stock rack (perhaps the one for the R25?)...
Quick question on kicker fuel and electrical power; in a factory setup, how is the fuel line and battery power line threaded through the transom to the kicker?
Hello, our windlass is no longer going up/down. We do hear it clicking. An electrician indicated that our solenoid needed to be replaced.
We've found the solenoid attached to the front panel within the helm panel (assessible from the head). How do you access it to replace it. There isn't...
Advice Wanted- planning to install the Garmin xHD Radar on my R23 next week. From what I understand, I will need to run the 2 wires through the mast base, remove the center ceiling decorative wood panel and then route the cables to the starboard mid cabin pillar where the porthole is. Remove...
I noticed on the new 2026 model R23/25/27, the AC Thru-Hull is different. It has a 90 elbow discharge. Now allows the water to come out and down and to a 45 aft. This is something I'm interested in converting my 2020 R23 discharge. Can't seem to find a part number. Did send a picture to the...
I’m having a Yamaha T 9.9 kicker installed on my 2019 R23 at my local Yamaha dealer. I’m wondering if you can provide details on running the fuel line from the installed fuel tank through the transom, to the motor.
Thanks,
Mike Rolnick
9407581171
Hi everyone.
We are new owners of a R-23OB and have been scouring the forum and learning a lot from all of you. Thank you for this forum!
We live on San Juan Island and will keep out new boat on our buoy most of the summer. We do have fresh water on our dock but we don’t keep the boat on the...
Hi, my buddy, who has a Grady White with a 250hp Yamaha, drove my R23 the other day. He says my motor doesn’t have the same range of motion as his does. In other words, at full port or starboard steering wheel lock his motor points further to port or starboard - which affects maneuverability -...
Hi, We just purchased a 2020 R-23 and saw that you had a davit for the R27ob. Do you have a solution for the r-23 as well? Do you still offer the one for the 27?
I own a 2019 R-23OB. I want to put a kicker on it. It has the installed motor mount on the swim platform. I’m not sure of the references for measuring shaft lengths. Will a Yamaha 15hp long shaft (20”) work, or do I need a 25” shaft. I ask because a local dealer has a new 2021 model that they...
I have a 2019 R-23 OB and want to put a kicker on it. The boat already has the bracket on the swim platform. I found a smoking good deal on a brand new 2021 Yamaha 15hp, but it is a long shaft (20" I think). Just checking with others that have experience with kickers regarding shaft length, and...
I am in the market for a used Ranger R-23 or R-25 in good condition with trailer. It will be run on Cape Cod and I am willing to travel. Thank you for your help!
2016 R23- I installed new batteries and a month later hired a tech to replace the original charger with a Victron IP22. Charging system seems to be working fine but on the solar remote meter display the red error light (top center) is on and the battery 1 icon is empty and flashing. I inspected...