I am new owner of R27 and am getting the Fluid Motion factory davit kit. What are the recommended RIBs to get here? Perhaps one fiberglass option and one aluminum option? Which tube type, PVC or other?
The other day during a strong wind the decking panel near the swim platform blew off. Can anyone tell me what type of adhesive I should use to reinstall the panel and how to apply ? There is non-skid decking underneath.
Thanks.
I just took possession of my 2025 Ranger 27 today. Love it. I can see the batteries fine when I'm on board if my bluetooth is connected. But now I'm trying to connect with the VRM. I found the 12-digit, entered it following the steps at https://vrm.victronenergy.com/add-installation, but the...
The latching mechanism for the sliding function on my 2025 R-27OB doesn't "catch". How do I access the slider under the seat to repair or replace it? US-FMLT2744K425 Thank you.
Hello,
I have a 2023 R-27 with the soft brown deck material in the aft cockpit. There are a few markings from black running shoes that I haven't been able to remove with deck wash. Tried Simply Green as well. Do you have any suggestions?
Many thanks!
2019 R27 OB questions:
#1. I want to rig a non-permanent starlink mini set up and want to use the 12v car charger port in the cockpit to power the dish—is the 12V cigarette lighter plug in the cockpit run off the starter or thruster batteries or the house bank?
#2 I have a small 113 Watt hour...
2019 R27 OB questions:
#1. I want to rig a non-permanent starlink mini set up and want to use the 12v car charger port in the cockpit to power the dish—is the 12V cigarette lighter plug in the cockpit run off the starter or thruster batteries or the house bank?
#2 I have a small 113 Watt...
Hi Jared,
I’m replacing the batteries in my RT27OB and I want to make sure that I am getting the right size and group. The batteries in the house bank are Interstate 31AGM 7 and the starter/thruster battery is the same dimensions and like the same size but a different brand.
Are these good...
Hello,
Is the swim ladder screwed in or bolted to the swim platform? Mine needs to be replaced, it is very rusty, and I am wondering if I need to access the top of the swim platform under the raptor deck to get at nuts for bolts?
Thank you
Colin Walsh
After using the bow thruster heavily while practicing docking for about an hour, I turned the boat off. When I returned an hour later and turned the boat on and pulled away from the dock the bow thruster made a loud, screeching type of sound and gave no thrust. The boat (R27) is brand new...
Ranger tug R-27 outboard, 2018, My mast light cover ended up missing? Blew off or ? In need of a new one, small round cover that twists on. Any suggestions on how to get on or locate on, Thanks, Rob Jannetti. Sequim.
Ranger tug R-27 (outboard) 2023 model year. The rear cover for one of the Fiamm electric horns has fallen off and gone missing. The horn(s) are A23 Airtone model. Do you know of a source to replace the missing part without having to buy an entirely new set of horns?
After trips where the boat didn’t really have to deal with seas or spray except on the hull, I notice that there is about a quart and a half or a half gallon of salt water in the far after bilge area right where the pump sits. The mid bilge by the second pump is just a bit damp as though a...
The CO monitor alarm in my boat seems overly sensitive. It sounds when I am taking fuel and the Yamaha F300 engine has been off for a minute or two.
In addition the alarm sounds (loud and distractingly obnoxious) when the boat is leaving the dock or taxiing slowly around the harbor—even with...
My 2023 R27 Steering slip a couple of times when turning either direction. I tried to locate my hydraulic fluid reservoir behind steering helm and under steering helm. Please pass on the location. I need to check the fluid level to eliminate why the steering slips while turning outboard.
I have the Bimini for the aft cockpit off for repair. Do you have any tips for reinstalling it easily (i.e. without trying to stretch it manually)? There appear to be small screws on some of frame parts. Are these to adjust tension in the frame? If so which ones do I adjust?
Thanks in advance.